Support
18" Triple-Zone Crash/Ride on Roland TD-27
Setup — 18" Triple-Zone Crash/Ride on Roland TD-27
WorksYes — the 18" Triple-Zone Crash/Ride works as a full 3-zone ride on the Roland TD-27: bow + bell + edge.
Bell
Bow
Edge
Wiring: 2× TRS → RD + RDB connectors on the DB-25 cable snake
Full 3-zone ride — the manual instructs connecting a ride that supports three-way triggering to the RD and RDB connectors of the dedicated connection cable.
Cable routing
- Connect a ¼″ TRS cable from the cymbal's Ride 1 output (bow/edge) to the RD (ride) connector on the cable snake.
- Connect a ¼″ TRS cable from the cymbal's Ride 2 output (bow/bell) to the RDB (ride bell) connector on the cable snake.
Module settings
- Press [SYSTEM], select "TRIGGER" and press [ENTER], then select "BANK" and press [ENTER] to open the TRIGGER BANK screen.
- Strike the ride (display shows "R") or use the cursor buttons to select the RIDE input.
- Use the dial to set the Trig Type to the model that matches your ride cymbal.
- Back on the TRIGGER MENU, open "PARAM", select the ride, then set Sensitivity from the cursor + dial.
Tips
- Both cables are required for full 3-zone operation (bell, bow, edge).
- If only one cable is connected, the ride will function as 2-zone only.
- The DIGITAL TRIGGER IN jacks support the CY-18DR digital ride, but Lemon cymbals use the analog snake inputs.
- If the edge and bell sounds come out swapped, the two cables are reversed — swap them at the cymbal ends.
18" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71