Free Shipping on All Orders
Lemon

Support

18" Triple-Zone Crash/Ride on Pearl Mimic Pro

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Pearl Mimic Pro.

Setup — 18" Triple-Zone Crash/Ride on Pearl Mimic Pro

Works

The 18" Triple-Zone Crash/Ride is fully supported on your Pearl Mimic Pro.

Bell Bow Edge

Wiring: 1× TRS → Ride 1 input + 1× TRS → Aux1 input (1/4" TRS jacks)

The Mimic Pro supports 3-zone ride using Ride 1 for bow/edge and an Aux input for bell. Explicitly documented.

Cable routing

  1. Connect the ride cymbal bow/edge cable to the Ride 1 input.
  2. Connect the ride cymbal bell cable to the Aux1 input (or another available Aux).
  3. Two separate 1/4" TRS cables are required for full 3-zone operation.

Module settings

  1. HOME > TRIGGER > Trigger Settings > select Ride 1 input.
  2. HOME > TRIGGER > Trigger Settings > select Aux1 input > configure as ride bell.
  3. Adjust Input Settings (Gain 0-17), Advanced (Threshold, Detect Time, Retrigger Cancel, Mask Time).

Tips

  1. The Mimic Pro explicitly documents 3-zone ride via Ride 1 + Aux configuration.
  2. Five Aux inputs (Aux1-5) are available for flexible routing.
  3. Bow, edge, and bell all trigger independently via separate inputs.