Official US store Free shipping Bundle & Save up to 20%
Lemon

Support

18" Triple-Zone Crash/Ride on Donner DED-300X

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Donner DED-300X.

Setup — 18" Triple-Zone Crash/Ride on Donner DED-300X

Use as 2-zone ride

Yes — the 18" Triple-Zone Crash/Ride works on the Donner DED-300X as a 2-zone ride: bow + edge.

Choose your ride zones

Plug: Ride 1

Wiring: 1× TRS: Ride 1 (bow/edge) → RIDE lead on the signal-connection harness

Plug the Lemon ride's Ride 1 cable into the Ride input for bow + edge — no cymbal modification. The DED-300X has a single Ride input, so two of the Lemon ride's zones reach the module.

Cable routing

  1. Connect a single 1/4" TRS cable from the cymbal's Ride 1 output (bow/edge) to the RIDE lead on the module's signal-connection harness (the harness plugs into the module via its multi-pin parallel-port connector).

Module settings

  1. Go to MENU > SENSITIVITY and select the Ride pad.
  2. The DED-300X has a single Ride input and does not expose a 3-zone ride pad type — the input reads the connected cable as a dual-zone cymbal.
  3. Adjust PS, RS, THREH, XTALK, RETRIGER, and VOLUME so bow and edge hits register cleanly.
  4. In your kit, load a ride-bow sample on the bow zone and a ride-edge or crash sample on the second zone.

Tips

  1. This is the out-of-the-box setup — no cymbal modification.

Or set it up as Bow + bell

Plug: Ride 2

Wiring: 1× TRS: Ride 2 (bow/bell, after the rewire) → RIDE lead on the signal-connection harness

After the one-time cymbal rewire the Ride 2 cable carries bow + bell into the single Ride input.

Rewire guide ›

Cable routing

  1. Rewire the cymbal — move the internal red/black jumper from the Ride 1 input to the Ride 2 input.
  2. Connect a single 1/4" TRS cable from the cymbal's Ride 2 output to the RIDE lead on this module's signal-connection harness.
Rewire guide ›

Module settings

  1. Go to MENU > SENSITIVITY and select the Ride pad.
  2. Adjust PS, RS, THREH, XTALK, RETRIGER, and VOLUME so bow and bell hits register cleanly.
  3. In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone.
18" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Audiofront

Donner

Efnote

GEWA

NUX

Pearl

Roland

Simmons

Yamaha

Support contact

Have a question? Read the FAQ. Need manual help? Email support.