Official US store. Free fast shipping from US
Lemon

Support

18" Triple-Zone Crash/Ride on Alesis Strata Prime

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Alesis Strata Prime.

Setup — 18" Triple-Zone Crash/Ride on Alesis Strata Prime

Works

The 18" Triple-Zone Crash/Ride is fully supported on your Alesis Strata Prime.

Bell Bow Edge

Wiring: 2× TRS → Ride trigger input + a Cymbal trigger input

The Ride trigger slot is natively 3-zone — Trigger Zone 1 Bow, Trigger Zone 2 Edge, Trigger Zone 3 Bell — so the pad's full bow/bell/edge layout reads with edge choke. The Lemon 3-zone ride is dual-output (two signal lines), so it lands on the dedicated Ride input plus one spare Cymbal input.

Cable routing

  1. Connect a 1/4" TRS cable from the ride's first signal output (bow/edge) to the Ride trigger input on the rear panel.
  2. Connect a second 1/4" TRS cable from the ride's second signal output (bell) to a free Cymbal trigger input on the rear panel.

Module settings

  1. Open Trigger Edit Mode and strike the ride bow, or use Hit Select, to select the Ride input; pick the matching trigger preset.
  2. Use Hit Select to select the Cymbal input carrying the bell and pick its preset.
  3. Tune Sensitivity and Threshold independently on each input; set Choke Time for the edge mute.

Tips

  1. Bow, Edge, and Bell each have their own Trigger Zone — edge choke registers when you grab the edge.
  2. If Edge and Bell feel swapped on either input, toggle Invert Bell & Edge there.
  3. If the bell is inconsistent, raise its Sensitivity and lower its Threshold.
  4. If the ride zones interfere with each other, run Learn XTalk on the input that is causing the crosstalk.
18" Triple-Zone Crash/Ride also fits 70 other drum modules — see setup

Other compatible drum modules

2Box

Alesis

ATV

Audiofront

Donner

Efnote

GEWA

Pearl

Roland

Simmons

Yamaha

Support contact

Have a question? Read the FAQ. Need manual help? Email support.