Support
18" Triple-Zone Crash/Ride on Yamaha DTX700
Setup — 18" Triple-Zone Crash/Ride on Yamaha DTX700
Use as 1-zone rideYes — the 18" Triple-Zone Crash/Ride works on the Yamaha DTX700 as a 1-zone ride: bow only.
Bell
Bow
Edge
Wiring: 1× TRS from the cymbal's Ride 2 output → RIDE trigger input jack — bow only
Full 3-zone is not supported — the DTX700 reads cymbal zones with Yamaha's own single-cable scheme (resistance-coded rim switches), which the Lemon ride's switch zones don't match. Connect the cymbal's Ride 2 output and play it as a bow-only ride.
Cable routing
- Connect the cymbal's Ride 2 output (bow + bell) to the RIDE trigger input jack.
Module settings
- Press [MENU], turn the dial to select Trigger, then select Pad.
- Hit the ride so the RIDE input is selected, then set PadType to the closest cymbal type (e.g. PCY135) — the bow triggers from its piezo regardless of the type chosen.
- Adjust Gain, MinLevel/MaxLevel, and RejectTime so bow strikes register cleanly.
Tips
- The Ride 2 output still carries bow and bell from the cymbal, but this module only registers the bow zone.
- Full simultaneous 3-zone operation is not available on this module.
18" Triple-Zone Crash/Ride also fits 73 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71