Free Shipping on All Orders
Lemon

Support

18" Triple-Zone Crash/Ride on Alesis Command

Wiring, module settings, and tips for the 18" Triple-Zone Crash/Ride when used with the Alesis Command.

Setup — 18" Triple-Zone Crash/Ride on Alesis Command

Reduced — 2-zone ride

The 18" Triple-Zone Crash/Ride works on your Alesis Command with reduced zones.

Bell Bow Edge

Wiring: 1× TRS (Cable 2) → RIDE connector on the cable snake — bow + bell

Full 3-zone is not supported — this module has a single Ride input. Connect Cable 2 (bow + bell) from the Lemon 3-zone ride cymbal; bow and bell zones both work through this cable.

Cable routing

  1. Connect Cable 2 (the bow + bell cable) from the Lemon 3-zone ride cymbal to the RIDE input.

Module settings

  1. Go to Kit → Menu → Trigger and select the RIDE input.
  2. Set the pad type to a 2-zone cymbal — the Command routes Ride through the snake and does not offer a 3-zone ride pad type.
  3. Adjust Sensitivity, Threshold, Curve, and Rim Sens for the input.
  4. In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone — bow and bell hits will play through Cable 2 as expected.

Tips

  1. Cable 2 delivers bow and bell — the two most-used zones for ride playing.
  2. Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.