Free Shipping on All Orders
Lemon

Support

T550 8" High Tom on Alesis Nitro Pro

Wiring, module settings, and tips for the T550 8" High Tom when used with the Alesis Nitro Pro.

Setup — T550 8" High Tom on Alesis Nitro Pro

Works

The T550 8" High Tom is fully supported on your Alesis Nitro Pro.

Head Rim

Wiring: 1× TRS per tom → Tom1, Tom2, Tom3 connectors on the 25-pin cable snake

The tom connectors on the cable snake support dual-zone (head + rim) triggering via center piezo and rim switch.

Cable routing

  1. Connect a 1/4" TRS cable from each tom pad to the Tom1, Tom2, or Tom3 connector on the 25-pin cable snake.

Module settings

  1. Go to Utility > use Page/Select buttons to navigate: SEN (Sensitivity), THR (Threshold), CUR (Curve).
  2. Select the Tom input and adjust parameters.
  3. R-S (Rim Sensitivity) controls rim zone response.

Tips

  1. Head triggers from the center piezo, rim triggers from the rim switch.
  2. Both zones respond independently on the TRS connection (tip = head, ring = rim).