Support

T550 10" Low Tom on Yamaha DTX400K

Wiring, module settings, and tips for the T550 10" Low Tom when used with the Yamaha DTX400K.

Yes — the T550 10" Low Tom works on the Yamaha DTX400K as a 1-zone tom: head only.

Head Rim

Wiring: 1× TRS per tom → TOM1, TOM2, TOM3 connectors on the DB-25 cable snake

The tom inputs on the cable snake support dual-zone (head + rim) triggering via center piezo and rim switch.

Connect a 1/4" TRS cable from each tom pad to the TOM1, TOM2, or TOM3 connector on the DB-25 cable snake.
Additional tom inputs may be available as direct jacks on the rear panel.

Hold the [KIT] button and press the [SONG] button to enter Menu Mode.
Press number button [5] to select the Trigger Settings group.
Press number button [5] for the Gain parameter, strike the tom to select it, then set the gain (1-127) with the number buttons.
Press number button [6] for the Minimum Level parameter, strike the tom, then set the minimum level (0-99 %).
If a tom double-triggers or picks up neighbouring pads, press number button [2] for the Crosstalk parameter, strike the tom, and raise its value (0-99).

Head triggers from the center piezo, rim triggers from the rim switch.
Both zones respond independently on the TRS connection (tip = head, ring = rim).

T550 10" Low Tom also fits 73 other drum modules — see setup

Other compatible drum modules

Have a question? Read the FAQ. Need manual help? Email support.