Free Shipping on All Orders
Lemon

Support

11" Dual-Zone Splash/Crash on Roland TD-17

Wiring, module settings, and tips for the 11" Dual-Zone Splash/Crash when used with the Roland TD-17.

Setup — 11" Dual-Zone Splash/Crash on Roland TD-17

Works

The 11" Dual-Zone Splash/Crash is fully supported on your Roland TD-17.

Bow Edge

Wiring: 1× TRS → CRASH1 connector on the DB-25 cable snake, or CRASH2 / AUX direct jack on the rear panel

Dual-zone crash triggering: bow (tip) and edge (ring) respond independently via the single TRS connection. Choke works by grabbing the cymbal edge. The TD-17 supports Roland CY-series 2-zone cymbals.

Cable routing

  1. Connect a ¼″ TRS cable from the cymbal to the CRASH1 connector on the DB-25 cable snake.
  2. For additional cymbals, connect to the CRASH2 or AUX input on the rear panel.

Module settings

  1. Press [SETUP] > Pad Settings > [F1] TYPE.
  2. Strike the cymbal pad or navigate to the CRASH1, CRASH2, or AUX input.
  3. Set the pad type to CY-12C or CY-13R depending on your cymbal size.

Tips

  1. Bow and edge zones respond independently.
  2. Choke works by grabbing the cymbal edge.
  3. CRASH2 and AUX are direct jacks on the rear panel, not part of the cable snake.