Free Shipping on All Orders
Lemon

Support

13" Triple-Zone Crash/Ride on GEWA G3

Wiring, module settings, and tips for the 13" Triple-Zone Crash/Ride when used with the GEWA G3.

Setup — 13" Triple-Zone Crash/Ride on GEWA G3

Works

The 13" Triple-Zone Crash/Ride is fully supported on your GEWA G3.

Bell Bow Edge

Wiring: 1× TRS → Ride input + 1× TRS → AUX1 input (1/4" TRS jacks)

The G3 supports 3-zone ride via the 3Way trigger type: Ride for bow/edge, AUX for bell.

Cable routing

  1. Connect the ride cymbal bow/edge cable to the Ride input.
  2. Connect the ride cymbal bell cable to the AUX1 input (or another available AUX).
  3. Two separate 1/4" TRS cables are required for full 3-zone operation.

Module settings

  1. [TRIGGER SET] button > SETTINGS > SETUP > set trigger type to 3Way.
  2. Valid 3Way combinations: Ride+AUX1, AUX1+AUX2, etc.

Tips

  1. The GEWA 3Way trigger type enables true 3-zone ride with separate inputs for bow/edge and bell.
  2. Refer to the G3 manual section on 3Way trigger configuration.