Support
13" Triple-Zone Crash/Ride on Roland TD-07
Setup — 13" Triple-Zone Crash/Ride on Roland TD-07
WorksThe 13" Triple-Zone Crash/Ride is fully supported on your Roland TD-07.
Bow
Edge
Wiring: 1× TRS → CRASH1 connector on the DB-25 cable snake, or CRASH2 / AUX direct jack on the rear panel
Dual-zone crash triggering: bow (tip) and edge (ring) respond independently via the single TRS connection. Choke works by grabbing the cymbal edge. The TD-07 supports Roland CY-series 2-zone cymbals.
Cable routing
- Connect a ¼″ TRS cable from the cymbal to the CRASH1 connector on the DB-25 cable snake.
- For additional cymbals, connect to the CRASH2 or AUX input on the rear panel.
Module settings
- Press [SETUP] > Pad Settings.
- Strike the cymbal pad or navigate to the CRASH1, CRASH2, or AUX input.
- Set the pad type to match your cymbal size.
Tips
- Bow and edge zones respond independently.
- Choke works by grabbing the cymbal edge.
- CRASH2 and AUX are direct jacks on the rear panel, not part of the cable snake.