Free Shipping on All Orders
Lemon

Support

13" Triple-Zone Crash/Ride on ATV xD-3

Wiring, module settings, and tips for the 13" Triple-Zone Crash/Ride when used with the ATV xD-3.

Setup — 13" Triple-Zone Crash/Ride on ATV xD-3

Reduced — 2-zone ride

The 13" Triple-Zone Crash/Ride works on your ATV xD-3 with reduced zones.

Bell Bow Edge

Wiring: 1× TRS (Cable 2) → Ride input — bow + bell

Full 3-zone is not supported — this module has a single Ride input. Connect Cable 2 (bow + bell) from the Lemon 3-zone ride cymbal; bow and bell zones both work through this cable.

Cable routing

  1. Connect Cable 2 (the bow + bell cable) from the Lemon 3-zone ride cymbal to the Ride input.

Module settings

  1. Open the trigger settings on the module and select the Ride input (the xD-3 manual is the authoritative menu reference).
  2. If the xD-3 exposes pad-type selection, set it to a 2-zone cymbal; otherwise the default dual-zone response applies.
  3. Adjust whatever sensitivity/threshold parameters the xD-3 offers until bow and bell strikes register without double-triggers.
  4. In your kit, load a ride-bow sample on the bow zone and a ride-bell sample on the second zone — bow and bell hits will play through Cable 2 as expected.

Tips

  1. Cable 2 delivers bow and bell — the two most-used zones for ride playing.
  2. Full simultaneous 3-zone operation is not available on this module — only one cable can be connected at a time.