Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

T950 13"x13" Floor Tom on Simmons Titan 50

Wiring, module settings, and tips for the T950 13"x13" Floor Tom when used with the Simmons Titan 50.

Setup — T950 13"x13" Floor Tom on Simmons Titan 50

Works

Yes — the T950 13"x13" Floor Tom works as a full tom on the Simmons Titan 50: head + rim.

Head Rim

Wiring: The "To Tom 1"–"To Tom 3" branches of the multi-pin cable harness → one per tom pad

The Titan 50's tom inputs are dual-zone, even though the kit's stock 8" tom pads are single-zone. A Lemon dual-zone tom pad triggers both head (center piezo) and rim (a second piezo mounted under the head) once Tom Type is set to Dual.

Snare and tom setup and troubleshooting guide ›

Cable routing

  1. Plug the "To Tom 1", "To Tom 2" or "To Tom 3" branch of the multi-pin cable harness into each tom pad.
Snare and tom setup and troubleshooting guide ›

Module settings

  1. Press the SETUP button, then strike the tom to select it (the LED to the right of the display shows the selected input).
  2. Press SETUP repeatedly to reach Tom Type and set it to "Dual" — this is what turns the rim on. Leave the third option, "Split", alone: it splits one tom input into two single-zone inputs for two separate tom pads, and no rim reads in that mode.
  3. Press SETUP repeatedly to step through Sens, Retrigger, Threshold, Curve, and X-Talk.
  4. Set Ratio to balance the rim zone against the head — a higher Ratio raises rim sensitivity.

Tips

  1. With Tom Type set to Dual, the head (center piezo) and rim (a second piezo mounted under the head) trigger as separate sounds.
  2. On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x13" Floor Tom also fits 76 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.