Support
T950 13"x13" Floor Tom on Millenium MPS-1000
Setup — T950 13"x13" Floor Tom on Millenium MPS-1000
WorksYes — the T950 13"x13" Floor Tom works as a full tom on the Millenium MPS-1000: head + rim.
Head
Rim
Wiring: Tom plugs on the multiple cable (Tom1, Tom2, Tom3) → one per tom pad; a fourth tom → 1× TRS → EXT jack (1/4")
All three tom channels on the multiple cable are dual-zone — head and rim are separate triggers. A fourth tom can use the EXT trigger jack, whose factory trigger type is the double-trigger mesh tom.
Snare and tom setup and troubleshooting guide ›Cable routing
- Plug the multiple cable's labelled tom plugs into the Lemon tom pads' 1/4" TRS jacks.
- For a fourth tom, connect a 1/4" TRS cable from the pad to the EXT trigger jack on the module's rear panel.
Module settings
- Press [SETUP], select 'ADVANCE' and press [ENTER], then hit the tom to select it.
- Set 'SENSITIVITY', 'HEADROOM', 'SENSETIME' and 'PEAK DECAY' for head and rim; balance the rim with 'RIM VELOCITY' and 'RIM MODIFIER'.
- For a tom on EXT, check that 'TRIGGER TYPE' is set to 'Mesh' (the factory setting).
Tips
- Tom MIDI notes (head / rim): Tom1 = 48/50, Tom2 = 45/47, Tom3 = 43/58, EXT = 41/39.
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x13" Floor Tom also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51
- Roland V71