Support
T950 13"x13" Floor Tom on Roland V71
Setup — T950 13"x13" Floor Tom on Roland V71
WorksYes — the T950 13"x13" Floor Tom works as a full tom on the Roland V71: head + rim.
Head
Rim
Wiring: 1× TRS per tom → TOM1, TOM2, TOM3 inputs (1/4" TRS jacks)
Dual-zone tom triggering: head (tip) and rim (ring) are read via the single TRS connection per tom input.
Snare and tom setup and troubleshooting guide ›Cable routing
- Connect a 1/4" TRS cable from each tom pad to the TOM1, TOM2, or TOM3 input on the rear panel.
Module settings
- Press the [TRIGGER] button.
- Press the [F1] (BANK) button to open the TRIGGER - BANK screen.
- Select the TOM1, TOM2, or TOM3 input (strike the pad or use the cursor buttons).
- Use the [-] [+] buttons or the dial to set the trigger type to the model that most closely matches your connected pad (the full trigger-type list is in the module's Data List).
- For finer control, press [F3] (BASIC) and adjust Sensitivity on the TRIGGER - BASIC screen.
Tips
- Head triggers from the center piezo, rim from a second piezo mounted under the head.
- Both zones share the one TRS connection (tip = head, ring = rim).
- On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x13" Floor Tom also fits 76 other drum modules — see setup
Other compatible drum modules
Alesis
Audiofront
Donner
Lekato
Millenium
Pearl
Roland
- Roland Octapad SPD-30
- Roland SPD-SX
- Roland SPD-SX PRO
- Roland TD-02
- Roland TD-07
- Roland TD-1
- Roland TD-4
- Roland TD-6
- Roland TD-8
- Roland TD-9
- Roland TD-10
- Roland TD-11
- Roland TD-12
- Roland TD-15
- Roland TD-17
- Roland TD-20
- Roland TD-25
- Roland TD-27
- Roland TD-30
- Roland TD-50
- Roland TD-50X
- Roland V31
- Roland V51