Official US store Free shipping Bundle & Save up to 15%
Lemon

Support

T950 13"x13" Floor Tom on Lekato PD708

Wiring, module settings, and tips for the T950 13"x13" Floor Tom when used with the Lekato PD708.

Setup — T950 13"x13" Floor Tom on Lekato PD708

Works

Yes — the T950 13"x13" Floor Tom works as a full tom on the Lekato PD708: head + rim.

Head Rim

Wiring: 1× TRS → TRIGGER IN 1/2 or 3/4 — head + rim

Each 2-zone tom needs one of the two jacks Lekato designates for dual-zone pads — TRIGGER IN 1/2 or 3/4 (User Manual p.7) — carrying head and rim over one TRS cable. Those two jacks are shared by every 2-zone pad you add, so a snare plus one tom already uses both. The other two jacks, 5/6 and 7/8, are designated for dual-zone cymbals, and the manual documents no setting that switches a jack between pad and cymbal use.

Snare and tom setup and troubleshooting guide ›

Cable routing

  1. Connect a TRS cable from the Lemon tom pad to a free TRIGGER IN jack — 1/2 or 3/4.
Snare and tom setup and troubleshooting guide ›

Module settings

  1. Open the SYSTEM menu, go to PAD SETUP and strike the tom to select its trigger.
  2. On PAGE 1, set SENSITIVITY and THRESHOLD, and raise MASK TIME or RETRIG LEVEL if a hit sounds twice.
  3. In the PAD menu, strike the head and choose a tom sound under Wave, then strike the rim and assign its sound.

Tips

  1. Only two jacks, 1/2 and 3/4, are designated for 2-zone pads — plan which pads claim them.
  2. A tom that doesn't need its rim can go on TRIGGER IN 5/6 or 7/8 with a mono TS cable — head only. The TS plug grounds the jack's second trigger, so no stray rim sounds.
  3. Raise ANTI CROSS between pads mounted on the same stand.
  4. On an input that reads head and rim, if the wrong zone plays, tune the module's head/rim settings for this pad's size; values set for a different-size pad may not carry over.
T950 13"x13" Floor Tom also fits 76 other drum modules — see setup

Support contact

Have a question? Read the FAQ. Need manual help? Email support.