Support
Setup for your 2Box DrumIt 5 MKII
Yes — Lemon pads cover snare, toms, kick, cymbals, ride, and hi-hat on the 2Box DrumIt 5 MKII.
- Snare 2-zone
- Toms 2-zone
- Kick 1-zone
- Crash 2-zone
- Ride 3-zone
- Hi-hat Continuous
Module snapshot
- Brand
- 2Box
- Model
- DrumIt 5 MKII
- Also known as
- DrumIt 5, DrumIt 5 MK2
Setup details by role
Snare pad 2-zone 1× TRS → the SNARE input
The snare input supports dual-zone (head + rim) triggering via the center piezo and the rim piezo.
Tom pad 2-zone 1× TRS per tom → the TOM 1–TOM 4 inputs
The tom inputs support dual-zone (head + rim) triggering via the center piezo and the rim piezo. There are four of them — TOM 1 to TOM 4 — and each is a Dual-Channel: the rim drives a second, independently editable trigger channel the module calls PERC 1–PERC 4.
Kick pad Works 1× TRS → the KICK input
Single-zone kick trigger. Only the head zone is active.
2-zone crash 2-zone 1× TRS → cymbal input (1/4" TRS jack)
Full dual-zone cymbal support with bow and edge.
3-zone ride 3-zone 2× TRS: bow/edge → CYMB A jack, bow/bell → the paired CYMB B jack (e.g. CYMB 3A + CYMB 3B)
Full 3-zone ride (bow, bell, edge). The DrumIt 5 MKII has no dedicated ride input — assign the ride to any CYMB channel. Each CYMB channel has paired A and B jacks, and the manual describes the B channels as "intended for pads that accommodate 2 stereo cables": the A jack reads bow (tip) + edge (ring), the B jack the bell. The Lemon ride's two cables map straight across.
Hi-hat Continuous 1× TRS pad → HIHAT A input + 1× TRS (controller) → HIHAT B input
Continuous hi-hat. The DrumIt 5 MKII's hi-hat channel calibrates the connected controller through its UNIT-HCAL page — set HTYP to DEF, trim the RAW value to match the pad, and run the CALIB routine to capture the pedal's closed and open end-points.
