Free Shipping on All Orders
Lemon

Support

12" 2-Piece Electronic Hi-Hat Cymbals on Alesis Prime

Wiring, module settings, and tips for the 12" 2-Piece Electronic Hi-Hat Cymbals when used with the Alesis Prime.

Setup — 12" 2-Piece Electronic Hi-Hat Cymbals on Alesis Prime

Works

The 12" 2-Piece Electronic Hi-Hat Cymbals is fully supported on your Alesis Prime.

Continuous Open Closed

Wiring: 1× TRS (pad) → HH input + 1× TRS (pedal) → HH Pedal input

Variable hi-hat pedal control is supported — the Lemon pedal drives open, closed, half-open, and splash articulations. Confirmed by Lemon Cymbals compatibility reference.

Cable routing

  1. Connect a ¼″ TRS cable from the hi-hat pad to the HH input on the rear panel.
  2. Connect a ¼″ TRS cable from the hi-hat pedal controller to the HH Pedal input on the rear panel.

Module settings

  1. Press the HH Setup button to enter hi-hat calibration mode.
  2. Adjust Pedal Bottom and Pedal Top to define the pedal travel range.
  3. Set Chick Gain to control foot chick/stomp response and Splash Sensitivity for splash sounds.

Tips

  1. Run the HH Setup calibration any time you change pedals or adjust the stand.
  2. The Prime provides 5 hi-hat trigger zones for detailed articulation across the full pedal range.
  3. Fine-tune Sensitivity (1.0–32.0) in Kit → Trigger Edit if response feels too hot or too soft.