Free Shipping on All Orders
Lemon

Support

11" Hi-Hat Controller on Alesis CORE

Wiring, module settings, and tips for the 11" Hi-Hat Controller when used with the Alesis CORE.

Setup — 11" Hi-Hat Controller on Alesis CORE

Works

The 11" Hi-Hat Controller is fully supported on your Alesis CORE.

Continuous Open Closed

Wiring: 1× TRS (pad) → HH input + 1× TRS (pedal) → HH Pedal input

Variable hi-hat pedal control is supported — the Lemon pedal drives open, closed, half-open, and splash articulations. Confirmed by Lemon Cymbals compatibility reference.

Cable routing

  1. Connect a ¼″ TRS cable from the hi-hat pad to the HH input on the rear panel.
  2. Connect a ¼″ TRS cable from the hi-hat pedal controller to the HH Pedal input on the rear panel.

Module settings

  1. Press the HH Setup button to enter hi-hat calibration mode.
  2. Follow the on-screen prompts to calibrate the pedal range.

Tips

  1. Run the HH Setup calibration any time you change pedals or adjust the stand.
  2. Adjust Sensitivity (1.0–32.0) in Kit → Trigger Mode if response needs fine-tuning.